PRODUCTS CENTER

Email:[email protected]

sae j1402 fuel high pressure braided air hose

Hose HOSE - Parker Hannifin

SAE 100R4 Suction & Return Line Hose Dry Air/Hot Water Multipurpose Multipurpose High Temperature Air Brake Hose SAE J1402 A Compressed Natural Gas and Liquefied Petroleum Gas Marine Fuel and Engine Hose SAE J1402 Al SAE J1402 All Hose 1/2

SAE J1402 Auto Rubber Air Brake Hose from China manufacturer

JYM SAE J1401 Air Brake Hose | Automotive Hose Manufactuing

Air Brake Hose is braided with high-quality, long-staple, manifold cotton threads, and have such very good performances as the following: good flexibiliby under pressure, ozone resistance, low-temperature resistance and high-temperature resistance, with stable

H213 Multi-Purpose Truck Hose SAE J1402

H213 Multi-Purpose Truck Hose. SAE J1402 TYPE AI, DOT AI. Manufacturer: Eaton Weatherhead. Recommended for: General purpose truck hose. For use in air brake, fuel, diesel fuel and high temperature petroleum oil appliions. Size -16 is not SAE J1402 or DOT approved for air brake appliions. Construction: braided, cloth cover design.

SAE 100R5 High-Temp Truck Hose (R5HT): …

Recommended for air brake, fuel, grease lines, high temperature petroleum oils and medium pressure hydraulic appliions. Meets all requirements of SAE100R5, D.O.T FMVSS 106 Type All, and SAEJ1402 Type II. Sizes -16 thru -24 are not SAE or DOT

Air Brake Hose: J1402 & J844 DOT, HAB - New-Line

Air Brake Hose: J1402 & J844 DOT, HAB - AUA. Anyone making brake asselies must register with DOT and ensure each assely complies with FMVSS-106. This section contains an expanding range of DOT air brake hoses - at this time New-Line does not stock hydraulic brake lines for passenger or on-road vehicles, buses, trucks, etc.

Air Brake Hose: J1402 & J844 DOT, HAB - New-Line

Air Brake Hose: J1402 & J844 DOT, HAB - AUA. Anyone making brake asselies must register with DOT and ensure each assely complies with FMVSS-106. This section contains an expanding range of DOT air brake hoses - at this time New-Line does not stock hydraulic brake lines for passenger or on-road vehicles, buses, trucks, etc.

J1402: Automotive Air Brake Hose and Hose Asselies - SAE …

2005/1/26· J1402_196804. This recommended practice covers minimum requirements for air brake hose asselies made from reinforced elastomeric hose and suitable fittings for use in automotive air brake systems including flexible connections from frame to axle, tractor to trailer, trailer to trailer and other unshielded air lines with air pressures up to 1

100R5 High Temp Hose | Hose and Fittings Source

100R5 High Temperature DOT Textile Covered Hydraulic Hose is Recommended for Medium Pressure Hydraulic Appliions using Petroleum Base Hydraulic Fluids. Used for Conveying Gasoline, Diesel Fuel, Oil, Water and Air. Tube is Black, Oil Resistant Nitrile. Cover is Blue, Oil Resistant Polyester Braid Impregnated w/Neoprene.

JYM SAE J1401 Air Brake Hose | Automotive Hose Manufactuing

Air Brake Hose is braided with high-quality, long-staple, manifold cotton threads, and have such very good performances as the following: good flexibiliby under pressure, ozone resistance, low-temperature resistance and high-temperature resistance, with stable

SAE J1402A Air Brake Hose < Brake System < Chassis & Body | …

Appliion. SAE J1402A air brake hose. Tube: EPDM | REINFORCEMENT: PET | COVER: EPDM. Exceptional weathering and ozone resistance. 2-spiral polyester reinforcement. Meets DOT FMVSS -106 requirements SAE J1402A dimensions. Temperature range -40 °F to 200 °F (-40 °C to 93 °C) Specifiions: 580-032-095 (Black)

J1402: Automotive Air Brake Hose and Hose Asselies - SAE …

2005/1/26· J1402_196804. This recommended practice covers minimum requirements for air brake hose asselies made from reinforced elastomeric hose and suitable fittings for use in automotive air brake systems including flexible connections from frame to axle, tractor to trailer, trailer to trailer and other unshielded air lines with air pressures up to 1

Air Brake Hose: J1402 & J844 DOT, HAB - New-Line

Air Brake Hose: J1402 & J844 DOT, HAB - AUA. Anyone making brake asselies must register with DOT and ensure each assely complies with FMVSS-106. This section contains an expanding range of DOT air brake hoses - at this time New-Line does not stock hydraulic brake lines for passenger or on-road vehicles, buses, trucks, etc.

SAE 100R5 DOT Hose | Hose and Fittings Source

Hose Ratings include: SAE 100R5 SAE J1402 type AII SAE J1402, DOT FMVSS 106 AII for Truck Air Brake (-04 thru -12) SKU ID Inch OD Inch Working psi Min Burst psi Min Bend Radius Inch Weight (lbs per foot) 04R5 3/16 0.52 3,000 12,000 3.0 0.15 05R5

Eaton Aeroquip SAE J1402 Air Brake Hose 2570-6 Hydraulic …

Air Brake SAE J1402 (FMVSS106) Hose, 0.38 Inch ID, Up to 225 PSI Eaton Aeroquip SAE J1402 Air Brake Hose 2570-6 Hydraulic Supply Co. JavaScript seems to be disabled in your browser.

TR500 High Temperature Air Brake Hydraulic Hose - SAE J1402 …

TR500 High Temperature Air Brake Hydraulic Hose - SAE J1402. Recommended for air brake hose, high temperature pressurized oil return lines and rotary oil/air compressor lines, engine and transmission coolant lines and lube oil lines. Meets or exceeds DOT FMVSS 106-74, SAE J1402 for air brake hose (4, 6, …

T5 TRUCKER - One Wire Braid 350-3050 psi Hose Polyester Braid Cover - RYCO Hydraulics

T5 may be used with compressed air if maximum working pressure is reduced by 30%. T5 hose is normally used where there is minimal abrasion to the outside cover. If abrasion is likely, support the hose away from the source of abrasion using mounting clamps, or protect with RWA Wire Armour or RSG Spiral Guard. T5 is a reduced bore hose.

H069 General Purpose Truck Hose SAE 100R5

H069 General Purpose Truck Hose. SAE 100R5, SAE J1402 TYPE II, DOT AII, ABS1. Manufacturer: Eaton Weatherhead. Recommended for: General purpose truck and hydraulic hose. For use in air brake, fuel hose, grease lines, high temperature petroleum oils and medium pressure hydraulic appliions. -16 thru -40 sizes are not SAE or DOT approved for

J1402: Automotive Air Brake Hose and Hose Asselies - SAE …

2005/1/26· J1402_196804. This recommended practice covers minimum requirements for air brake hose asselies made from reinforced elastomeric hose and suitable fittings for use in automotive air brake systems including flexible connections from frame to axle, tractor to trailer, trailer to trailer and other unshielded air lines with air pressures up to 1

Eaton Aeroquip SAE J1402 Air Brake Hose 2570-6 Hydraulic …

Air Brake SAE J1402 (FMVSS106) Hose, 0.38 Inch ID, Up to 225 PSI Eaton Aeroquip SAE J1402 Air Brake Hose 2570-6 Hydraulic Supply Co. JavaScript seems to be disabled in your browser.

Air Brake Hose: J1402 & J844 DOT, HAB - New-Line

Air Brake Hose: J1402 & J844 DOT, HAB - AUA. Anyone making brake asselies must register with DOT and ensure each assely complies with FMVSS-106. This section contains an expanding range of DOT air brake hoses - at this time New-Line does not stock hydraulic brake lines for passenger or on-road vehicles, buses, trucks, etc.

Air Brake Hose Supplier - Industrial Hoses Solution

Air Brake Hose Tube: EPDM; Cover: EPDM Reinforcement: High strength polyester braid WP: 290 psi Temperature: -35 C to 75 C Special Features: To SAE J1402 Size Range: 10mm to 13mm Appliion: Truck braking systems. WANRONG INDUSTRY

SAE 100R5 Truck Hose (R5): DiscountHydraulicHose - Page 2 …

SAE 100R5 General Purpose/Truck Hose Recommended for air brake, fuel, grease lines, high temperature petroleum oils and medium pressure hydraulic appliions Interchanges with: Weatherhead H069, Aeroquip 1503 and Parker 201.

H213 Multi-Purpose Truck Hose SAE J1402

H213 Multi-Purpose Truck Hose. SAE J1402 TYPE AI, DOT AI. Manufacturer: Eaton Weatherhead. Recommended for: General purpose truck hose. For use in air brake, fuel, diesel fuel and high temperature petroleum oil appliions. Size -16 is not SAE J1402 or DOT approved for air brake appliions. Construction: braided, cloth cover design.

air brake hose-brake hose-SAE J1402-air brake rubber hose

air brake hose SAE J1402 Structure:EPDM tube + ployester fiber spiral line + EPDM cover Appearance:mill finish, black Applicable temperature:-40 to 100 c Appliion:This type of rubber hose is applied to vehicle air brake system. air brake hose appliion includes the flexible connection between frame and axle, tractor and trailer and between trailers, as well as unprotected air circuit with

SAE J1402A Air Brake Hose _3292 Hydraulic Supply Co.

SAE J1402 A, DOT AII, FMVSS106 Air Brake Hose, Up To 225 PSI. -40°F to +212°F. EC038 is manufactured with a highly engineered EPDM tube and cover and reinforced with a traditional polyester braid, delivering performance and value to the customer. Tractor to trailer lines, axle chaer lines and tractor service lines.

Desert DUT Hydraulic Hose - SAE J1402 | Continental

SAE J1402. Continental ContiTech Desert DUT Hydraulic Hose is best used for high pressure fleet appliions. Compatible with petroleum oil and phosphate ester-based hydraulic fluids, air, water, diesel fuel, petroleum-based lubriing oils and coolants. Reinforced by one braid textile and one braid steel.

1503-24 | Danfoss PowerSource

SAE 100R5, SAE J1402 Burst Pressure (bar) 140 Burst Pressure (psi) 2000 Color Black Description Single Wire Braid Family Hose General Appliion Hydraulics, Air, Gasoline, Fuel & Lubriing Oils Hose Base Nuer 1503 Inside Diameter (in) 1.38 35.1

Eaton® - H069 Truck Hose, 1-3/8-24" ID, 1-3/4" OD, 50'' Length, 10-1/2" Bend Radius, 500PSI Working Pressure, SAE 100R5, SAE J1402 …

Eaton® - H069 Truck Hose, 1-3/8-24" ID, 1-3/4" OD, 50'' Length, 10-1/2" Bend Radius, 500PSI Working Pressure, SAE 100R5, SAE J1402 Type II - 64470 24 JavaScript is disabled in your browser which limits the functionality of the website.

SAE 100R5 Truck Hose (R5): DiscountHydraulicHose

SAE 100R5 General Purpose/Truck Hose Recommended for air brake, fuel, grease lines, high temperature petroleum oils and medium pressure hydraulic appliions Interchanges with: Weatherhead H069, Aeroquip 1503 and Parker 201.